![]() Open up a browser and type in the 192.168.1.1 IP address.I will not be connecting this router to the Internet, so I left the DNS servers blank. The router will be on 192.168.1.1, so give it an IP above that. Configure your Ethernet adapter properties for IPv4 to an IP in the 192.168.1.x range.Download the latest firmware file from the Ubiquiti website, at, onto your computer.If you are using a different EdgeRouter, the steps may be slightly different. Note: These steps are for setting up the EdgeRouter Poe-5. I do also list the specific steps that I used to get my EdgeRouter setup below, as some steps in the video may not be very clear. This video,, is helpful in getting the router setup. First, let's do the setup of the EdgeRouter. Now that we have the basis of our race WiFi network, we need to get it all setup. If you use PoE on one of these routers, I recommend putting a label on the top of the router, over the port, to remind you that PoE is on. If you plug a device that does not support PoE into a port that has PoE turned on, the device can be damaged. They only support passive PoE, which means that there is no handshaking between the router and a connected device to determine if the device supports PoE. It certainly has a much nicer price point.Ī word of warning regarding PoE on the ERPoe-5 and ER-X. If you are not expecting really large numbers of mobile devices connecting to the network, an ER-X may work just fine for you. I ended up going with the ERPoe-5 for the greater throughput and 48V PoE capability. Additionally, the ERPoe-5 does offer more throughput than the ER-X (3 Gbps vs. So, the ERPoe-5 can directly power one or more compatible access points. What the ERPoe-5 does offer over the ER-X is that it can provide 24V or 48V PoE on each of the ports. A 4th port can also be used, but there is a performance penalty to use it along with the switched ports. ERPoe-5 - The ERPoe-5 has 3 switched ports.You would have to use a 48V PoE injector for those latter two. While it has a 24V PoE capability, that can only power a Lite access point, not the Pro or nanoHD. ER-X - The ER-X is very inexpensive and gives you 4 switched ports to use for devices.That's an extra piece of gear, and I am trying for the least complicated equipment setup, if possible. You can make a ERLite-3 (or the Ubiquiti USG, which is the UniFi equivalent to the ERLite-3) work if you also get a managed gigabit switch to give you enough ports to work with. ![]() It only gives you two ports to use for your devices, which would be your laptop, an access point and nothing else.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |